3 o3: p-p auto exposure coarse adjustment – Kodak 2400DSV User Manual

Page 100

Function Mode and Adjustment

6.7.3 o3: P-P Auto Exposure Coarse Adjustment

This adjustment is made when the image density on the print (scan)
output in the Auto Exposure mode is not satisfactory.

This adjustment is necessary after the replacement of PWB-A and PWB-
BB.

1. Turn the Power Switch, set the Auto Exposure Mode into Auto and

select the center position of exposure level.

2. Make a print (scan) and check the image density.

Print Mode .............Text
Film Type ................Posi

3. Refer to the charts given below.

Then, adjust to desired image density by Function Mode o3.

Setting

Function

Image density

4 step lighter

Lighter

Darker

3 step lighter

2 step lighter

1 step lighter

Standard

1 step darker

2 step darker

3 step darker

4 step darker

Be sure to adjust the Projection Lamp Voltage (F7) and
Shading Correction (b6) before this Adjustment.