KTI Networks KGS-2416 User Manual
Page 180
176
There are three parameters, Auto, True and False, used to configure the
type of the point-to-point link. If configure this parameter to be Auto, it
means RSTP will use the duplex mode resulted from the auto-negotiation.
In today’s switched networks, most links are running in full-duplex mode.
For sure, the result may be half-duplex, in this case, the port will not fast
transit to Forwarding state. If it is set as True, the port is treated as point-
to-point link by RSTP and unconditionally transited to Forwarding state. If
it is set as False, fast transition to Forwarding state will not happen on
this port.
Default: Auto
M Check:
Migration Check. It forces the port sending out an RSTP BPDU instead
of a legacy STP BPDU at the next transmission. The only benefit of this
operation is to make the port quickly get back to act as an RSTP port.
Click
specified.