KORG TRITON Extreme music workstation/sampler - Manual (Page 94)

90
Linking the arpeggiator to programs and
combinations
You can specify whether the arpeggiator settings written
into a program or combination will also be selected when
you select a program or combination, or whether the cur-
rent arpeggiator settings will be retained even if you
switch programs or combinations.
When shipped from the factory, the former setting is
selected. Choose the latter setting if you want to keep the
same arpeggio pattern running while you switch only the
program or combination.
If the Auto Arpeggiator “Program” or “Combination” box
is checked, the arpeggio settings will also change when
you select a program or combination respectively.
System Preference page
Recalling the last-selected mode and page
at power-on
The state of TRITON Extreme when the power is turned
on will depend on the setting of “Power On Mode”.
If “Power On Mode” is Reset (factory setting), TRITON
Extreme will automatically selects the Combination mode
P0: Play.
If “Power On Mode” is Memorize, TRITON Extreme will
power on using the same mode and page that were last
selected when the power was turned off.
The Memorize setting will remember the mode and page
that were last selected, the combination number that was
last selected in Combination mode, and the program
number that was last selected in Program mode. If
another mode is selected when the power is turned on,
you can press the [COMBI] key or [PROG] key to select
the P0: Play page with the last-selected combination num-
ber or program number.
Sounding a beep when you press the LCD
screen
If the “Beep Enable” check box is checked, a beep will
sound when you press an object in the LCD screen.
Uncheck this item if you don’t want a beep to sound.
Protecting the memory
If one or more of the Memory Protect check boxes are
checked, operations such as writing, loading, or song
recording will be prohibited for the corresponding type of
memory.
Input/Sampling page
Making audio input settings for other than
Sampling mode
☞ Refer to p.107 and PG p.159.
MIDI-related settings P1: MIDI
MIDI Setup, MIDI Filter
☞ Refer to PG p.161.
Pedal and other controller
settings
P2: Controller
Specifying the function of the ASSIGNABLE
Switch and ASSIGNABLE Pedal
Sets the function of an assignable switch such as the
optional Korg PS-1 connected to the ASSIGNABLE
SWITCH
jack.
• This is set by “Foot Switch Assign.”
This switch can act as a source for alternate modulation or
effect dynamic modulation, or switch portamento on/off,
control the sostenuto effect, turn the soft pedal effect on/
off, turn the arpeggiator on/off, select programs or combi-
nations (up/down), start/stop the sequencer, punch-in/
out on the sequencer, or be a trigger and tap tempo to
advance the cue list step (
☞PG p.281).
You can specify the function that will be performed by an
assignable pedal (the optional XVP-10 or EXP-2) con-
nected to the ASSIGNABLE PEDAL jack.
• This is set by “Foot Pedal Assign.”
This pedal can be used to control master volume, alternate
modulation or effect dynamic modulation, portamento