Kodak DCS Pro 14n - Manual (Page 86)

5-18 April 29, 2004
Configuring your Camera
Long Exposure
You can enable or disable a long exposure feature on your camera. When
enabled, this feature reduces noise in long exposures.
The choices are:
Off—If you capture an image using long exposure while this feature is Off,
a message suggests that you enable it.
Long—Suggested for exposures up to 1/2 sec.
Longer—This choice allows you to specify ISO and Exposure settings
during long exposures to improve the image quality.
1. Choose Long Exposure from the Capture menu.
2. Choose Off, Long, or Longer.
3. Press the OK button.
If you chose Off or Long, the setting has been changed.
If you chose Longer, the following screen appears:
a. Press the top or bottom of the Four-way switch to change the ISO
setting. Press the left or right of the Four-way switch to change
exposure. (In the example above, ISO is set to 400 and exposure
is set to 1 sec.)
NOTE: While enabled, this exposure setting overrides the existing
exposure setting and you cannot change exposure using the
Main-Command dial.
b. Press the OK button.