Sun Microsystems 5602 - Manual (Page 269)

A – Command Line Interface
Show Command
59097-01 A A-95
0
LIP_F8_AL_PS This LIP denotes a loop failure detected by the L_Port
identified by AL_PS.
LIP_F7_F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIP_F8_F7 A loop initialization primitive frame used to indicate that a loop
failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization or a loss of signal while not
in the offline state. A loss of signal causes the switch to attempt
to re-establish the link. If the link is not re-established, a link
failure is counted. A link reset is performed after a link failure.
Login Number of device logins
Logout Number of device logouts
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by this
port. A loss of synchronization is detected by receipt of an
invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
RxLinkResets Number of link reset primitives received from an attached
device.
RxOfflineSeq Number of offline sequences received. An OLS is issued for
link initialization, a Receive & Recognize Not_Operational
(NOS) state, or to enter the offline state.
TotalErrors Total number of errors detected.
TotalLIPsRecvd Number of loop initialization primitive frames received by this
port.
TotalLIPsXmitd Number of loop initialization primitive frames transmitted by
this port.
TotalLinkResets Total number of link reset primitives.
TotalOfflineSeq Total number of Offline Sequences issued and received by this
port.
TotalRxFrames Total number of frames received by this port.
TotalRxWords Total number of words received by this port.
Table A-27. Show Port Parameters (Continued)
Entry Description