Sun Microsystems 5602 User Manual
Page 237
A – Command Line Interface
Set Config Command
59097-01 A
A-63
0
AutoPerfTuning
Automatic performance tuning for FL_Ports only. The default
is True.
If AutoPerfTuning is enabled (True) and the port is an
FL_Port, MFSEnable is automatically enabled.
LCFEnable and VIEnable are overridden to False.
If AutoPerfTuning is disabled (False), MFSEnable,
LCFEnable, and VIEnable retain their original values.
LCFEnable
Link control frame preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True) or
disables (False) preferred routing of frames with R_CTL =
1100 (Class 2 responses). The default is False. Enabling
LCFEnable will disable MFSEnable.
MFSEnable
Multi-Frame Sequence bundling. This parameter appears
only if AutoPerfTuning is False. Prevents (True) or allows
(False) the interleaving of frames in a sequence. The default
is False. Enabling MFSEnable disables LCFEnable and
VIEnable.
VIEnable
Virtual Interface (VI) preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True) or
disables (False) VI preference routing. The default is False.
Enabling VIEnable will disable MFSEnable.
MSEnable
Management server enable. Enables (True) or disables
(False) management server on this port. The default is True.
NoClose
(1-Gbps/2-Gbps ports
only)
Loop circuit closure prevention. Enables (True) or disables
(False) the loop’s ability to remain in the open state
indefinitely. True reduces the amount of arbitration on a loop
when there is only one device on the loop. The default is
False.
Table A-18. Set Config Port Parameters (Continued)
Parameter
Description