A-26 – Sun Microsystems 5602 User Manual
Page 260
A – Command Line Interface
Set Setup Command
A-86
59097-01 A
0
system
Prompts you in a line-by-line fashion to change system configuration settings.
describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity
Trap community password that authorizes an SNMP agent to
receive traps. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The
trap community password can be up to 32 characters excluding
#, semicolon (;), and comma (,). The default is “public”.
AuthFailureTrap
Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
ProxyEnabled
Enables (True) or disables (False) SNMP communication with
other switches in the fabric. The default is True.
Note:
Changing the IP address will terminate all Ethernet management
sessions.
Table A-26. System Configuration Settings
Entry
Description
Eth0NetworkDiscovery
Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Eth0NetworkAddress
Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Eth0NetworkMask
Ethernet subnet mask address.
Eth0GatewayAddress
Ethernet IP address gateway.
AdminTimeout
Amount of time in minutes the switch waits before
terminating an idle Admin session. Zero (0) disables the
time out threshold. The default is 30, the maximum is
1440.
InactivityTimeout
Amount of time in minutes the switch waits before
terminating an idle Telnet command line interface
session. Zero (0) disables the time out threshold. The
default is 0, the maximum is 1440.
Table A-25. SNMP Configuration Settings (Continued)
Entry
Description