Siemens SICLOCK TC 400 - Manual (Page 73)

Parameterization and Operation on the Device
8-71 © Siemens AG 2007 All Rights Reserved
SICLOCK
® TC 400
8.2.1 Authorization (enter password)
A password in the form of a 10-digit decimal number must be entered so that the
operator can make entries on the device.
You can operate the device after successful authorization.
If no entry is made for 30 seconds, the display automatically switches to the oper-
ating display and you have to log on again in order to make entries.
To enter the password on the device:
1. Press the SETUP key.
−> The entry dialog box for the password appears.
2. Enter the password with the arrow keys
↑ ↓ ← →
and confirm the input with
OK.
− Password was correct
−> the parameter list is displayed. You can operate the device in accor-
dance with your authorization level.
− Display has switched to operating display
−> The password input is automatically cancelled 30 seconds after the last
key is pressed.
Repeat your password input.
− Password was incorrect and is not accepted by the device
−> A message appears that the password has not been accepted.
Repeat the input with a correct password.
The password input can be aborted at any time with ESC.
Password:
0000000000