Siemens SICLOCK TC 400 User Manual

Page 49

Configuration Tool

7-47

TC 400

Example of the /Display/View (0.10.01) parameter with the entries "Language"
and "Time":

Figure 7-2 Parameter view

Working with the configuration tool

To start the configuration tool:

1. Open the Web browser.

2. Enter the address of the device port, e.g. 192.168.1.10

3. If necessary, confirm the installation and execution of the applet with "Yes" or

"Always".

−> The configuration tool is started and displayed in the browser.

To parameterize the SICLOCK TC 400 with the configuration tool:

1. Connect the configuration tool to the SICLOCK TC 400 with the

button.

2. For a new parameterization of the device, load the parameters to the configu-

ration tool with the

button or open an existing parameter file (*.u600) with

the

button.

3. Parameterize the SICLOCK TC 400 according to your hardware configuration

and your requirements.

In online mode, changes take effect immediately on the device.

4. Save the configuration as parameter file (*.u600) on your PC with the

button.

Note

Note the information in your browser about restrictions because of strict safety
settings.

Note

In order to be able to access the last version of the SICLOCK TC 400 parameter-
ization, we recommend that you save the current parameterization of SICLOCK
TC 400 as *.u600 file before you make any changes.