4 mounting position and fixing method, 1 installation instructions, Mounting position and fixing method – Siemens SICLOCK TC 400 User Manual

Page 31: Installation instructions

Operation Planning

4-29

TC 400

4.4

Mounting position and fixing method

4.4.1

Installation instructions

Before installing the device, read the following general installation instructions.

• Position the device/display in an ergonomic position favorable to the user.

Choose a suitable installation height.

• Position the device/display so that it is not subject to direct sunlight or other

strong sources of light.

• Provide adequate volume in the control cabinet for air circulation and heat

transport. Maintain a clearance of 100 mm above and below. This clearance
is increased accordingly with connection cables.

• Position the device so that the air vents of the housing are not covered up fol-

lowing installation.

• Also provide enough free space for device expansions.
• Note the reinforcement in the control cabinet for stabilizing the installation cut-

out. Install reinforcement if required.

• Install the device in such a way that there is no danger, for example, of it falling

out.

• During assembly, please comply with the permissible mounting positions.

Warning

Hazardous voltage

Isolate the power supply to the control cabinet before opening it. Ensure that the
power to the control cabinet cannot be turned on accidentally.