Sun Microsystems Sun Fire X4150 Server - Manual (Page 55)

Chapter 4 Configuring the Preinstalled Solaris 10 Operating System 45
TABLE 4-1 Installation Worksheet
Installation Information Description Enter System Configuration:
Asterisk (*) indicates default.
Language Choose from the list of available languages for
the Solaris 10 software. English*
Locale Choose your geographic region from the list of
available locales. English
(C - 7-bit ASCII)*
Terminal Choose the type of terminal that you are using
from the list of available terminal types.
Network connection Is the system connected to a network? Networked
Non-networked*
DHCP Can the system use Dynamic Host Configuration
Protocol (DHCP) to configure its network
interfaces? Yes
No*
If you are not
using DHCP,
note the
network
address. IP
address If you are not using DHCP, supply the IP address
for the system.
Example: 129.200.9.1
Subnet If you are not using DHCP, is the system part of a
subnet?
If yes, what is the netmask of the subnet?
Example: 255.255.0.0 255.255.0.0 *
IPv6 Do you want to enable IPv6 on this machine? Yes
No*
Host name A host name that you choose for the system.
Kerberos Do you want to configure Kerberos security on
this machine?
If yes, gather the following information:
Default Realm:
Administration Server:
First KDC:
(Optional) Additional KDCs: Yes
No*
Name service: if
the system uses
a name service,
provide the
following
information. Name
service Which name service should this system use? NIS+
NIS
DNS
LDAP
None*
Domain
name Provide the name of the domain in which the
system resides.