Sun Microsystems Sun Fire X4150 Server - Manual (Page 47)

Chapter 3 Setting Up the Sun Fire X4150 Server 37
2. Ensure that the server hardware is installed and cables are inserted.
3. Verify that your terminal, laptop, PC, or terminal server is operational.
4. Configure the terminal device or the terminal emulation software running on a
laptop or PC to the following settings:
■ 8N1: eight data bits, no parity, one stop bit
■ 9600 baud
■ Disable hardware flow control (CTS/RTS)
■ Disable software flow control (XON/XOFF)
5. Connect a null serial modem cable from the server’s back panel RJ45 serial port to
a terminal device (if not connected already).
See FIGURE 1-5 for the serial port position.
6. Press Enter on the terminal device to establish a connection between the terminal
device and the Embedded LOM service processor (SP). The following prompt
appears.
- >
7. Type the default user name root, and then type the default password: changeme
to log in to the Embedded LOM SP.
The Embedded LOM displays a default command prompt, indicating that you have
successfully logged in:
->
8. Type the following command to determine the SP IP address:
show /SP/network
9. After the status has been determined, view the output of show /SP/network.
DHCP enabled is shown as IPSource = dhcp
10. To assign a static IP ADDRESS, type the following commands in exact order:
set /SP/network IPSource=static
set /SP/network IPAddress=xxx.xxx.xxx.xxx
set /SP/network Netmask=xxx.xxx.xxx.xxx
set /SP/network Gateway=xxx.xxx.xxx.xxx
Where xxx = IP address numbers
Example 2
To change the service processor (SP) static IP address to a DHCP IP address using
the serial connection (system management port), perform the following steps: