Sun Microsystems Sun Fire X4150 Server - Manual (Page 41)

Chapter 3 Setting Up the Sun Fire X4150 Server 31
Note – The factory has configured the service processor hardware and firmware on
your server with the most common settings used in the field. You may not need to
change these defaults.
See the Embedded Lights Out Manager (ELOM) Administration Guide for detailed
information.
Connecting the Cables
Connect the power and data cables from the server back panel to your system.
Connector Locations
See FIGURE 3-1 and TABLE 3-2 for the locations of the back panel connectors .
FIGURE 3-1 Back Panel Connectors
TABLE 3-2 Back Panel Connector Legend
Label Item Label Item
1 Power supply unit 0 connector 5 Service processor (SP) network management NET
MGT Ethernet port
2 Power supply unit 1 connector 6 Gbit Ethernet ports LAN-0, 1, 2, 3 (Intel)
3 System status LEDs 7 USB 2.0 ports (0, 1)
4 Serial management/RJ-45 serial port 8 HD15 video connector