Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 2000592-001 - Manual (Page 40)

Setting Network Address
Description This section provides instructions to configure the ANCB/DN.
Command Line
Definitions Chapter 3, Command Line Summary, provides definitions for all of the
commands you will be using in this chapter.
Instructions 1. Connect a standard 9-pin COM cable from the designated PC COM
1 to the RS232 Configuration Connector on the ANCB (see Figure
4-1).
2. Open Windows HyperTerminal program on your PC; reference
Configuring Your PC, page 22.
3. Connect and Log on to Advance Maxum ANCB; reference
Establishing a Connection, page 27.
The Connect Screen will appear with the login information and the
local prompt. The local prompt indicates that you are communicating
with the unit connected directly to the PC.
Ver 1.0
30
• Data Communications Setup
2000592-001