Instructions, continued, Datanet copper connections, Continued – Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 2000592-001 User Manual

Page 25

Text mode
Original mode

DataNET Copper Connections,

Continued

Instructions,
continued

Step Action

Strip the insulation ¼ -inch back from each of the incoming
copper leads.

To make the connections easier we have made the ANCB
port connector a removable connector. Grasp the top
portion of the connector and pull it straight out from the
base connector. Loosen all the top wire retaining screws
from the removed connector. All connections will be made
to this connector.

Connect Channel A leads to pins 1 through 3 and Channel
B leads to pins 4 through 6. Tighten down the retaining
screws.

DataNET PORT

CONNECTIONS

Pin 1

Pin 2

−

Pin 3- Ground
Pin 4-

Pin 5

−

Pin 6- Ground

Plug Port connector back into its base.

2000592-001

Installation

• 15