Siemens ADVANCE NETWORK COMMUNICATIONS BOARD/DATANET 2000592-001 - Manual (Page 13)

ANCB/DN Specifications
Protocol and Addressing Open Systems standard TCP/IP protocol and addressing
(Transmission Control Protocol/Internet Protocol); Full Class A, B and
C addresses and subnet masking supported
Wiring Connections
• Two part connectors with screw-terminals provided for cable
connection
• Fiber Optic Coupler for Fiber Optic Connections
DataNET Option, Standard
Cable • Cable connection by Belden 9182 (single pair) or Belden
SSD1743 (two pairs) or equivalent; two pairs of wires are
required to support redundancy
• Two pairs of cable is required to support redundancy
• Shielded cable or unshielded cable in conduit is required for
conformance to CE certified installation
• Two part connectors with screw-terminals provided for field
connection
DataNET Option, Fiber Optic
Cable • Fiber optics connection by 62.5 multi-mode cable corresponding
to 10BaseFL Ethernet specification
• Two pairs of fibers are required to support redundancy
• Type ST mating connectors provided for field connection
• Approximately 3 mbps base transmission rate; uses dedicated
transmission technique that does not require collision detection to
achieve high data throughput efficiency
• Maximum Length 5000 feet ( 1.7km)
Fiber Optic Coupler
• Two (Tx, Rx) ST-Style Connectors (Amp type 2.5mm Bayonet)
Serial Port • Standard RS-232 port for attachment of a laptop computer, for
configuring IP Addresses and troubleshooting.
Communication
Comparisons The Table below compares key communication features between using
Advance Data Hiway, Ethernet, or DataNET.
Feature Advance Data Hiway Ethernet DataNET
Speed 14.2 KB/Sec 10 M baud 2. 048 M baud
Redundant Yes No Yes
Number of Units in
Maxum System 248 1200 1200
2000592-001 Installation
• 3