Sierra Wireless DART 200 CDPD Modem - Manual (Page 67)

DART 200 CDPD Modem User’s Guide 5 DART Supported Protocols
PN1197-00 Revision 1.0 5-13
Table 5-2. Host UDP setup
AT Command Req Opt Def Description
AT^Annn.nnn.nnn.nnn R Input IP Address (if not already done)
AT\N[1,2] R Side Preference - (get from carrier)
AT\J0 D Use default - No channel access
restrictions
AT\R4 R Auto Registration at Power On
ATS13=0 R With AT\R4 sets Continuous
Automatic Registration
AT\O0 R PAD mode required for UDP.
AT*A0 D Use default - No server function
required
AT*L2100 D Use default - Listen on port 2100
ATS82=0 R Turn off backward compatibility.
ATE0 O No command mode character echo
ATV0 O Use terse result codes
ATQ0 D Use default - Result codes are sent to
the host
ATF1 D Use default - Do not echo transmitted
data to the host
ATX1 D Use default - Extended result codes
AT&C1 D Use default - DCD follows state of
the connection
AT&D0 D Use default - You may want to
consider using DTR to escape
AT&E2 O Filter escape sequence from output
AT&S0 D Use default - DSR is always active
AT\F3 D Use default - Applies only if \M1
specified
AT\M0 D Use default - Do not recognize data
forwarding characters
AT\Q2 D Use default - Most PC’s use flow
control
AT\T1 D Timed data forwarding - Always use
with binary data
AT*B0 D Use default - Many CDPD Carriers
have not implemented Broadcast.
AT*C1 D Use default - Does not apply to UDP
AT*G1 D Use default - Does not apply to UDP
AT*K0 D Use default - Does not apply to UDP
AT*R0 D Use default - Does not apply to UDP
AT*T0 D Use default - Does not apply to UDP