Sierra Wireless DART 200 CDPD Modem User Manual
Page 158
DART 200 CDPD Modem User’s Guide
F DART AT Command Set
Sierra Wireless, Inc.
F-14
Table F-3. Commands beginning with backslash (\) (cont.)
\J (cont.)
Format:
AT\J0
No restrictions on channel selection (default)
AT\J1
LSAI (CDPD 1.0) or WASI (CDPD 1.1) mode . Use only channels that have the
same LSAI or WASI as the active NEI. Will be forced by \N0.
AT\J2
SPNI mode. Use only channels that have the same SPNI as the modem.
AT\J3
Use only channels that have the same SPNI and LSAI (CDPD 1.0) or WASI
(CDPD 1.1) as the active NEI in the modem.
AT\J4
SPI mode. Use only channels that have the same SPI as the modem (CDPD 1.1
only).
AT\J5
SPI and WASI limitations apply (CDPD 1.1 only).
AT\J6
SPI and SPNI limitations apply (CDPD 1.1 only).
AT\J7
SPI, WASI, and SPNI apply (CDPD 1.1 only).
Result codes:
OK
Valid argument
ERROR
Invalid argument
\M
Manual Transmit Control
Controls the recognition of data forwarding characters by the packet assembler while in online mode.
If enabled, the DART recognizes the reception of either of the two data forwarding characters from the
MAS as a condition to transmit any pending data. The data forwarding characters are defined in S-
Registers 51 (default is 13
more information.
The AT\F command determines whether the forwarding characters are themselves included in the
packet. If manual transmit control is disabled, any forwarding characters are included in the packet
regardless of their disposition as defined by the AT\F command.
Format:
AT\M0
Disable recognition of data forwarding character (default)
AT\M1
Enable data forwarding character recognition, and use the conditional status of
the AT\F command
Result codes:
OK
Valid argument
ERROR
Invalid argument
\N
Set Side Preference
Allows the MAS to set the modems side preference. The side preference identifies the CDPD Service
Provider and determines which group of cellular channels the modem searches for a useable CDPD
channel.
\N settings are not reset by ATZ, AT-R, or power cycling the modem
Format:
AT\N0
Home only mode. Alias for (and forces) \J1; does not specify a side setting.
Only allows use of channels that have the same LSAI (CDPD 1.0) or WASI
(CDPD1.1) as the active NEI
AT\N1
A side only