Sierra Wireless DART 200 CDPD Modem - Manual (Page 152)

DART 200 CDPD Modem User’s Guide F DART AT Command Set
Sierra Wireless, Inc. F-8
Table F-1. Commands beginning with letters (cont.)
X Extended Result Codes
Selects whether the DART enables extended result codes. By default all result codes are enabled.
Format:
ATX0 Enable only codes 0...4 Extended results are mapped as appropriate to code 0...4
ATX1 Enable all extended result codes (default)
Result codes:
OK Valid argument
ERROR Invalid argument
Z Soft Reset
Performs a soft reset on the DART, aborting any active connection, and resets all modem profile
parameters to their saved values. The network registration status is not affected.
Format:
ATZ
Perform soft reset
Result code:
OK Command complete
? Read Selected Register
Returns the value of the register selected by the S command.
Format:
AT?
Read value of most recently selected register
ATSn? Read value of register
ATS? Read value of register 0
Result codes:
A numerical value, decimal or hexadecimal (denoted by a leading 0x), representing the contents of
the specified S-Register.
ERROR Invalid register number
= Write Selected Register
Alters the value in the currently selected S-Register. The format of the parameter is numeric or text,
depending on the particular register being modified. Numeric values are specified in decimal. If the
S register contains text then this command must be last on the command line.
Format:
ATSn=x Set register to
AT=x Sets selected register (last one referenced explicitly) to
Result codes:
OK Valid parameter value
ERROR Invalid value for selected register, or register is read only (RO)
NOT ENABLED Must be in Service Provider mode to alter this register