Sierra Wireless DART 200 CDPD Modem - Manual (Page 168)

DART 200 CDPD Modem User’s Guide F DART AT Command Set
Sierra Wireless, Inc. F-24
Table F-4. Commands beginning with asterisk (*) (cont.)
*U Unblock Modem - PIN Access
Can be used to unblock the modem if the PIN is forgotten or is entered incorrectly 3 times. The modem
is unblocked for the express purpose of entering a new PIN. Whenever this command is executed,
follow it immediately by the Set PIN command (AT\P=) to set a new (or restore the old) PIN value
when the current PIN is not subject to validation.
If the Set PIN command is not executed the modem remains in the unblocked state until the next power
cycle, or until a command requiring the PIN is successfully executed.
The default unblocking key is 12345678.
If the unblocking key is entered incorrectly 10 times in succession this command also becomes
BLOCKED. This condition can be cleared by using the AT^C command. Refer to Chapter 3, CDPD
Security Features, Modem security management, for more information.
Format:
AT*U+ Enters the Unblocking Key
Result codes:
OK Valid argument
ERROR Invalid argument
BLOCKED Command ignored
Service provider commands
The Service Provider commands provide the user with the means to
initialize the modem for use on the CDPD network, to alter protected
S-Registers, and to execute diagnostic commands.
Table F-5. Enable/Disable Service Provider mode
^P Enable/Disable Personalization Mode
This command must be issued before any other Service Provider commands can be executed. It puts
the DART into service provider mode and enables the other service provider commands to be executed
as well as permitting data to be stored in protected S-Registers (see Appendix E). The default is
51348954.
Format:
AT^P-
Disable Personalization Mode
AT^P+ Enable Personalization Mode
Result codes:
OK Valid argument
ERROR Invalid argument
BLOCKED An invalid key was used three or more times.