Sanyo IDC-1000ZU - Manual (Page 84)

3
Press c on the arrow button to select the AE shift
icon < .
AE shift sequential shot: Select <
Normal sequential shot: Select U
œ If the exposure control setting (see page 92) is set to a
setting other than program AE, then the AE shift icon
< cannot be selected. For the AE shift sequential
shot, change the exposure control setting to program
AE (see page 94).
4
Press the SET button.
œ This completes the AE shift sequential shot setting.
œ The AE shift sequential shot setting returns to the
normal sequential shot if the mode selector dial is
turned, the CAMERA/PLAY switch is changed, or the
digital disk camera is turned off.
œ To exit the Shooting Setting Screen, press the MODE
button.
5
Press the shutter release button.
œ The AE shift sequential shot is taken.
œ While the AE shift sequential shot images are being
captured, the
b icon will appear in the monitor.
œ Even after the AE shift sequential shot is finished, the
AE shift sequential shot setting remains unchanged.
NOTE
œ For the AE shift sequential shot, even if you have set the exposure correction (see page 87),
the exposure correction value is returned to
á 0 and then the AE shift sequential shot is
captured.
œ For the sequential shot shooting mode, the Y compression ratio cannot be set.
About the sequential shot speed
œ The sequential shot speed for sequential shots depends on the resolution.
Resolution R : 7.5 images/second (approx. 0.13 seconds/image)
Resolution Q : 7.5 images/second (approx. 0.13 seconds/image)
Resolution P : 30 images/second (approx. 0.03 seconds/image)
HELP
If the exposure does not change
œ If the subject is too bright or too dark, the exposure may not change as required.
100-0101
1 / 1 / 4 3
4 . 4 . 1
Recording mark
83
English