Sanyo IDC-1000ZU - Manual (Page 30)

Using the AC power supply
Use the supplied AC adapter/charger to operate the digital disk camera with an AC power supply
(by connecting to a power outlet).
Caution
œ The AC adapter/charger is for exclusive use with this digital disk camera (IDC-1000ZEX,
IDC-1000ZE, IDC-1000ZU). Do not use it with any other device.
œ If the AC ADAPTER lamp is flashing, there is likely a problem with the AC adapter/charger. If it
is flashing, immediately unplug the power cord from the power outlet and contact the place of
purchase (see page 26).
1
Insert the supplied power cord into the socket on the
AC adapter/charger.
œ Insert the power cord straight and until it is fully seated.
2
Plug the DC cord into the DC IN terminal on the
digital disk camera.
3
Plug the power cord into a power outlet (AC 100 to
240 V).
4
Turn on the digital disk camera (see page 32).
œ When the digital disk camera is turned on, the green
AC ADAPTER lamp turns on.
œ If charging is being performed at this time, charging is
stopped automatically and AC power is supplied to the
digital disk camera. (The red BATTERY CHARGE
lamp turns off and the green AC ADAPTER lamp turns
on.)
Power cord
AC adapter/
charger
Power button
DC cord
DC plug
DC IN terminal
Terminal cover
BATTERY CHARGE
lamp (red)
AC ADAPTER lamp (green)
To AC
29
English