Sanyo IDC-1000ZU - Manual (Page 157)

1
Press j on the arrow button to select “ YES.”
œ There are two types of format screens. Both are
shown to the right.
œ If the Quick Format Screen with the quick format icon
t appears, select “NO” and press the SET button to
display a screen that allows you to select the full
format process. At this screen, select “FULL FORMAT”
and press the SET button.
œ If the Full Format Screen with the full format icon u
appears, connect the supplied AC adapter/charger
(see page 29). If the AC adapter/charger is not
connected, you cannot reformat the disk.
2
Press the SET button.
œ Formatting starts.
œ During formatting, “FORMATTING” appears.
œ Do not turn off the digital disk camera while it is
formatting a disk.
œ A full format requires approximately 20 minutes.
œ To cancel formatting, press the MODE button. (To
cancel the full formatting process, press the MODE
button after the status bar appears.) If you cancel the
format, be sure to properly format the disk later.
œ When “FORMATTING” disappears and you return to
the normal operation screen, formatting has been
completed successfully.
œ If formatting cannot be completed properly for a disk,
the disk may be damaged. Replace the disk with a
new one.
HELP
If “ PROTECTED” appears
œ The write-protect tab on the disk is set to the key ( è ) mark. To format the disk, the
write-protect tab must be set to the write-enabled position.
NOTE
œ A newly purchased disk may display the Quick Format Screen or the Full Format Screen
depending on how they were formatted before packaging. This is not a malfunction.
DISK TOOLS
REFORMAT
REFORMAT?
YES
ÄNO
Quick Format Screen
Full Format Screen
DISK TOOLS
REFORMAT
REFORMAT?
YES
ÄNO
AC ADAPTER
REQUIRED
Quick Format Processing Screen
DISK TOOLS
REFORMAT
FORMATTING
DON'T POWER OFF
Full Format Processing Screen
Indicator of format process
DISK TOOLS
REFORMAT
FORMATTING
DON'T POWER OFF
English
156