Sanyo IDC-1000ZU - Manual (Page 144)

8
Press the MODE button.
œ You return to the Compile Program Screen.
œ Proceed to steps 9 and 10. At this point, the program
has not yet been saved.
9
Press l on the arrow button to select “ SAVE” and
press the SET button.
œ It will take a few moments for the program to be saved
to the disk.
œ Once saved, the Save Program Screen appears with
the program number.
œ In the example given on the right, the program was
assigned the program number “0001.”
10
Press the SET button.
œ The Compile Program Screen appears. The program
has been compiled and saved.
œ To return to the Program Playback Setting Screen,
press the MODE button. To then return to the Program
Playback Selection Screen, press the MODE button
again, or select “EXIT” and press the SET button. To
then return further back to the Playback Setting
Screen, press the MODE button, or select “EXIT” and
press the SET button.
Compile Program Screen
PROGRAM
FOLDER 100
IMAGE SEL
MOVIE SEL
ÄSAVE
Program number
Save Program Screen
PROGRAM
SAVED AS 0001
Compile Program Screen
PROGRAM
ÄFOLDER Е100Д
IMAGE SEL
MOVIE SEL
SAVE
23/08/2001
19:00
143
English