Sun Microsystems Sun StorEdge 5210 NAS - Manual (Page 19)

Chapter 2 Turning the Sun StorEdge 5210 NAS On and Off 7
8. Press the Power button (Figure 2-3) on the front panel (behind the front cover).
FIGURE 2-3 Power Switch and Front Panel Detail
Network Setup and System
Configuration
For a detailed explanation of network setup and system configuration, refer to the
Software Installation, Configuration, and User Guide "Introduction" on the
documentation CD.
If DHCP is supported, the IP address is automatically configured when you power
the system up for the first time.
Note – Write down the IP address for use in system configuration.
Network Setup without DHCP
If your network does not support DHCP, you must manually configure the IP
address using the NAS filer LCD panel controls by pressing the Select button once,
selecting Set Static IP, and selecting or specifying the required information and
saving the settings.