Sun Microsystems FIRE V40Z - Manual (Page 28)

6 Sun Fire V20z and Sun Fire V40z Servers, Server Management Guide • May, 2004
Operator Panel
You can use the operator panel to configure network settings for the SP. See
FIGURE 1-2 or FIGURE 1-3 for the operator panel location on your server.
Note – The SP defaults to Dynamic Host Configuration Protocol (DHCP)
networking if the operator panel is not interactively engaged on the first power-up.
FIGURE 1-2 Sun Fire V20z Server Operator Panel and Buttons
FIGURE 1-3 Sun Fire V40z Server Operator Panel and Buttons
Operator panel display Operator panel buttons
Operator panel display
Operator panel buttons (3)