Sun Microsystems FIRE V40Z - Manual (Page 229)

Appendix H Service Processor Commands 207
SP Set SMTP Server Subcommand
Description: Configures the SP SMTP client with the information for the remote
SMTP server, including the address and optional port number.
Format
Command format:
sp set smtp server [{-f | --from} FROM FIELD ] IP OR HOSTNAME OF SMTP
SERVER
TABLE H-67 lists the arguments for this subcommand.
The value you supply is prepended onto @hostname | ip_address. The default
value is system.
For example, if you enter admin for sp_22, email messages are sent from
admin@sp_22
.
If the host name is not set, the IP will be used as follows: [email protected].
Return Codes
TABLE H-68 lists the return codes for this subcommand.
TABLE H-67 Arguments for Subcommand sp set smtp server
Arguments Description
{-f | --from} Specifies the from field for the SMTP server.
IP OR HOSTNAME OF SMTP SERVER Specifies the IP address or the host name of the
SMTP server.
TABLE H-68 Return Codes for Subcommand sp set smtp server
Return Code ID Description
NWSE_Success 0 Command successfully completed.
NWSE_InvalidUsage 1 Invalid usage: bad parameter usage, conflicting
options specified.
NWSE_RPCTimeout 2 Request was issued, but was not serviced by the
server. RPC procedure timed out and the request
may or may not have been serviced by the server.
NWSE_RPCNotConnected 3 Unable to connect to the RPC server.