Return codes, Sp get port 80 subcommand, Format – Sun Microsystems FIRE V40Z User Manual
Page 208
186
Sun Fire V20z and Sun Fire V40z Servers, Server Management Guide • May, 2004
Return Codes
lists the return codes for this command.
SP Get Port 80 Subcommand
Description: Retrieves the last Port 80 post code from the PRS Port80 register. The
register is written by platform BIOS during platform boot. This command is used to
debug platform boot problems.
Format
Command format:
sp get port80 {-m | --monitor}
TABLE H-42
lists the arguments for this subcommand.
You can also retrieve the last ten Port 80 post codes using the operator panel.
For more details about using the operator-panel menus, refer to the Sun Fire V20z
Server User Guide (817-5248-xx).
See
for a list of the Power On Self Test (POST) codes for the Phoenix
BIOS.
See
for a list of the boot block codes on Flash ROM.
TABLE H-41
Return Codes for Subcommand sp create test events
Return Code
ID
Description
NWSE_Success
0
Command successfully completed.
NWSE_InvalidUsage
1
Invalid usage: bad parameter usage, conflicting options
specified.
NWSE_RPCTimeout
2
Request was issued, but was not serviced by the server.
RPC procedure timed out and the request may or may
not have been serviced by the server.
NWSE_NoMemory
8
Insufficient memory.
TABLE H-42
Arguments for Subcommand sp get port80
Argument
Description
{-m | --monitor}
Allows for continuous monitoring of the port 80 traffic.