Sp set locatelight subcommand, Format, Return codes – Sun Microsystems FIRE V40Z User Manual
Page 203
Appendix H
Service Processor Commands
181
SP Set Locatelight Subcommand
Description: Sets the state of the locatelight switch (which describes the state of the
front and rear panel identification lights).
Format
Command format:
sp set locatelight {blink | off}
Return Codes
TABLE H-34
lists the return codes for this subcommand.
TABLE H-34
Return Codes for Subcommand sp set locatelight
Return Code
ID
Description
NWSE_Success
0
Command successfully completed.
NWSE_InvalidUsage
1
Invalid usage: bad parameter usage, conflicting
options specified.
NWSE_RPCTimeout
2
Request was issued, but was not serviced by the
server. RPC procedure timed out and the request may
or may not have been serviced by the server.
NWSE_RPCNotConnected
3
Unable to connect to the RPC server.
NWSE_NoPermission
6
Not authorized to perform this operation.