Ethernet interface commands, Interface ethernet – SMC Networks SMC2552W-G2-17 User Manual
Page 225

Command Line Interface
7-88
7
Ethernet Interface Commands
The commands described in this section configure connection parameters for the
Ethernet port and wireless interface.
interface ethernet
This command enters Ethernet interface configuration mode.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 10/100Base-TX network interface, enter the following command:
Table 7-16. Ethernet Interface Commands
Command
Function
Mode
Page
interface ethernet
Enters Ethernet interface configuration mode
GC
dns primary- server
Specifies the primary name server
IC-E
dns secondary- server
Specifies the secondary name server
IC-E
ip address
Sets the IP address for the Ethernet interface
IC-E
ip dhcp
Submits a DHCP request for an IP address
IC-E
speed-duplex
Configures speed and duplex operation on the
Ethernet interface
IC-E
shutdown
Disables the Ethernet interface
IC-E
show interface ethernet
Shows the status for the Ethernet interface
Exec
Enterprise AP(config)#interface ethernet
Enterprise AP(if-ethernet)#