Snmp commands – SMC Networks SMC2552W-G2-17 User Manual
Page 177

Command Line Interface
7-40
7
SNMP Commands
Controls access to this access point from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
Table 7-9. SNMP Commands
Command
Function
Mode
Page
snmp-server community
Sets up the community access string to permit access
to SNMP commands
GC
snmp-server contact
Sets the system contact string
GC
snmp-server location
Sets the system location string
GC
snmp-server enable server
Enables SNMP service and traps
GC
snmp-server host
Specifies the recipient of an SNMP notification
operation
GC
snmp-server trap
Enables specific SNMP notifications
GC
snmp-server engine id
Sets the engine ID for SNMP v3
GC
snmp-server user
Sets the name of the SNMP v3 user
GC
snmp-server targets
Configures SNMP v3 notification targets
GC
snmp-server filter
Configures SNMP v3 notification filters
GC
snmp-server
filter-assignments
Assigns SNMP v3 notification filters to targets
GC
show snmp groups
Displays the pre-defined SNMP v3 groups
Exec
show snmp users
Displays SNMP v3 user settings
Exec
show snmp
group-assignments
Displays the assignment of users to SNMP v3 groups Exec
show snmp target
Displays the SNMP v3 notification targets
Exec
show snmp filter
Displays the SNMP v3 notification filters
Exec
show snmp
filter-assignments
Displays the SNMP v3 notification filter assignments Exec
show snmp
Displays the status of SNMP communications
Exec