SMC Networks SMC2552W-G2-17 - Manual (Page 135)

System Configuration
6-88
6
Event Logs
The Event Logs window shows the log messages generated by the access point and
stored in memory.
The Event Logs table displays the following information:
• Log Time: The time the log message was generated.
• Event Level: The logging level associated with this message. For a description of
the various levels, see “logging level” on page 6-32.
• Event Message: The content of the log message.
Error Messages – An example of a logged error message is: “Station Failed to
authenticate (unsupported algorithm).”
This message may be caused by any of the following conditions:
• Access point was set to “Open Authentication”, but a client sent an authentication
request frame with a “Shared key.”
• Access point was set to “Shared Key Authentication,” but a client sent an
authentication frame for “Open System.”
• WEP keys do not match: When the access point uses “Shared Key Authentication,”
but the key used by client and access point are not the same, the frame will be
decrypted incorrectly, using the wrong algorithm and sequence number.
CLI Commands for Displaying the Logging Status – From the global configuration
mode, use the show logging command.
Enterprise AP#show loggging 7-32
Logging Information
============================================
Syslog State : Enabled
Logging Console State : Enabled
Logging Level : Alert
Logging Facility Type : 16
Servers
1: 192.168.1.19, UDP Port: 514, State: Enabled
2: 0.0.0.0, UDP Port: 514, State: Disabled
3: 0.0.0.0, UDP Port: 514, State: Disabled
4: 0.0.0.0, UDP Port: 514, State: Disabled
=============================================
Enterprise AP#