General commands – SMC Networks SMC2552W-G2-17 User Manual
Page 144

General Commands
7-7
7
The access mode shown in the following tables is indicated by these abbreviations:
Exec
(Executive Mode), GC (Global Configuration), IC-E (Interface-Ethernet
Configuration), IC-W (Interface-Wireless Configuration), and IC-W-VAP
(Interface-Wireless VAP Configuration).
General Commands
SNMP
Configures community access strings and trap managers
Flash/File
Manages code image or access point configuration files
RADIUS
Configures the RADIUS client used with 802.1X authentication
802.1X Authentication Configures 802.1X authentication
MAC Address
Authentication
Configures MAC address authentication
Filtering
Filters communications between wireless clients, controls access to the
management interface from wireless clients, and filters traffic using
specific Ethernet protocol types
WDS Bridge
Configures WDS forwarding table settings
Spanning Tree
Configures spanning tree parameters
Ethernet Interface
Configures connection parameters for the Ethernet interface
Wireless Interface
Configures radio interface settings
Wireless Security
Configures radio interface security and encryption settings
Rogue AP Detection
Configures settings for the detection of rogue access points in the
network
Link Integrity
Configures a link check to a host device on the wired network
IAPP
Enables roaming between multi-vendor access points
VLANs
Configures VLAN membership
WMM
Configures WMM quality of service parameters
Table 7-3. General Commands
Command
Function
Mode
Page
configure
Activates global configuration mode
Exec
end
Returns to previous configuration mode
GC, IC
exit
Returns to the previous configuration mode, or exits the CLI
any
ping
Sends ICMP echo request packets to another node on the
network
Exec 7-10
reset
Restarts the system
Exec
show history
Shows the command history buffer
Exec
show line
Shows the configuration settings for the console port
Exec
Table 7-2. Command Groups
Command Group
Description
Page