SMC Networks SMC2552W-G2-17 - Manual (Page 170)

System Clock Commands
7-33
7
show event-log
This command displays log messages stored in the access point’s memory.
Syntax
show event-log
Command Mode
Exec
Example
System Clock Commands
These commands are used to configure SNTP and system clock settings on the
access point.
Enterprise AP#show event-log
Mar 09 11:57:55 Information: 802.11g:11g Radio Interface Enabled
Mar 09 11:57:55 Information: 802.11g:Radio channel updated to 8
Mar 09 11:57:34 Information: 802.11g:11g Radio Interface Enabled
Mar 09 11:57:18 Information: 802.11g:11g Radio Interface Enabled
Mar 09 11:55:52 Information: SSH task: Set SSH server port to 22
Mar 09 11:55:52 Information: SSH task: Enable SSH server.
Mar 09 11:55:52 Information: Enable Telnet.
Mar 09 11:55:40 Information: 802.11g:Transmit Power set to QUARTER
Press next.
previous. abort. continue to end :
Enterprise AP#configure
Enter configuration commands, one per line. End with CTRL/Z
Enterprise AP(config)#logging clear
Table 7-7. System Clock Commands
Command Function Mode Page
sntp-server ip Specifies one or more time servers GC 7-35
sntp-server enable Accepts time from the specified time servers GC 7-35
sntp-server date-time Manually sets the system date and time GC 7-36
sntp-server
daylight-saving
Sets the start and end dates for daylight savings time GC 7-37
sntp-server timezone Sets the time zone for the access point’s internal clock GC 7-37
show sntp Shows current SNTP configuration settings Exec 7-38