beautypg.com

0 device description, 1 detailed product description, 2 definitions – Samsung MUXONENAND A-DIE KFM2G16Q2A User Manual

Page 8

background image

MuxOneNAND2G(KFM2G16Q2A-DEBx)

- 8 -

FLASH MEMORY

MuxOneNAND4G(KFN4G16Q2A-DEBx)

2.0 DEVICE DESCRIPTION

2.1 Detailed Product Description

The MuxOneNAND is an advanced generation, high-performance NAND-based Flash memory.

It integrates on-chip a single-level-cell (SLC) NAND Flash Array memory with two independent data buffers, boot RAM buffer, a page buffer for
the Flash array, and a one-time-programmable block.

The combination of these memory areas enable high-speed pipelining of reads from host

,

BufferRAM

,

Page Buffer

,

and NAND Flash Array.

Clock speeds up to 66MHz / 83MHz with a x16 wide I/O yields a 108MByte/second bandwidth.

The MuxOneNAND also includes a Boot RAM and boot loader. This enables the device to efficiently load boot code at device startup from the
NAND Array without the need for off-chip boot device.

One block of the NAND Array is set aside as an OTP memory area, and 1st Block (Block 0) can be used as OTP area. This area, available to
the user, can be configured and locked with secured user information.

On-chip controller interfaces enable the device to operate in systems without NAND Host controllers.

2.2 Definitions

B (capital letter)

Byte, 8bits

W (capital letter)

Word, 16bits

b (lower-case letter)

Bit

ECC

Error Correction Code

Calculated ECC

ECC that has been calculated during a load or program access

Written ECC

ECC that has been stored as data in the NAND Flash array or in the BufferRAM

BufferRAM

On-chip internal buffer consisting of BootRAM and DataRAM

BootRAM

A 1KB portion of the BufferRAM reserved for Boot Code buffering

DataRAM

A 4KB portion of the BufferRAM reserved for Data buffering

Sector

Part of a Page of which 512B is the main data area and 16B is the spare data area.
It is also the minimum Load/Program/Copy-Back Program unit
during a 1~4 sector operation is available.

Data unit

Possible data unit to be read from memory to BufferRAM or to be programmed to memory.
- 528B of which 512B is in main area and 16B in spare area
- 1056B of which 1024B is in main area and 32B in spare area
- 1584B of which 1536B is in main area and 48B in spare area
- 2112B of which 2048B is in main area and 64B in spare area

This manual is related to the following products: