Siemens gigaset SE551 User Manual
Page 102
100
Configuring the Advanced Settings
Gigaset SE551 WLAN dsl/cable / deutsch / A31008-M1029-B101-1-19 / configure_router.fm / 25.10.2006
Sc
hablone 2
004_
12_2
7
Super G (108 Mbit/s)
With the aid of channel bundling, the
transmission mode enables wireless data
transfer up to 108 Mbps. The channel for wireless data transfer cannot be changed. You
can only use Super G if this function is supported by at least one client in your wireless
network. For the best possible data transfer rates, all clients in your LAN should support
Super G.
ì
Select the mode for using Super G (108 Mbit/s) for your wireless network to incre-
ase the data transmission speed. You have a choice of two modes.
– Static: Wireless transmission is at a rate of just 108 Mbps. Clients that do not
support this speed cannot connect to Access Point.
– Dynamic: If you select this transmission mode, the router accepts subscribers
that communicate at different transfer rates and adjusts to the slowest client in
the network.
ì
If you do not wish to use Super G (108 Mbit/s), select Disabled in the selection
menu.
XR (extended range)
Activating XR enables data transfer even in the peripheral areas of your wireless net-
work, albeit at very low data transfer rates. Conversion to XR mode occurs automatically
when the signal is weak enough and if the partner station is also XR capable.
ì
Activate or deactivate
for your wireless network to increase the range.
ì
Click on OK to apply the settings.
Please remember:
If you activate Super G as the transmission mode, but it is not supported by all compo-
nents in your wireless network, then for technical reasons the transfer rate in the net-
work may be significantly lower than the possible maximum of 108 Mbit/s.