Sanyo PLC-XK3010 - Manual (Page 9)

9
(MIC)-
Part Names and Functions
Rear Terminal
② ③ ①
⑥
⑤
⑧
④
④ VIDEO IN
Connect the composite video output signal
to this jack (p.15).
② COMPUTER IN 1 /S-VIDEO IN /
COMPONENT IN
Connect output signal from a computer,
component video output, RGB scart 1-
pin video output or S-video output to this
terminal. (pp.14-16).
⑥ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this
jack (pp.14-16).
This terminal outputs sound from AUDIO IN
terminal.
⑤ LAN Connection Terminal
Connect the LAN cable (refer to the owner’s
manual of “Network Set-up and Operation”).
① CONTROL PORT
When the projector is controlled by a
computer, connect to this jack with serial
control cable.
③ COMPUTER IN 2 / MONITOR OUT
– Connect analog RGB output signal from a
computer to this terminal (p.14).
– This terminal can be used to output the
incoming analog RGB and Component
signal from COMPUTER IN 1 /S-VIDEO
IN /COMPONENT IN terminal to the other
monitor (pp.14,16).
⑦
⑦ AUDIO IN (PC/MIC)
Connect the audio output signal from
computer or video equipment connected to
② and ③ to this jack. Or connect the MIC to
this jack. (pp.14-16).
⑧ AUDIO IN (L/R) L/R)
Connect the audio output signal from video
equipment connected to ④ to this jack. For
a mono audio signal (a single audio jack),
connect it to L(MONO) jack. (p.15).
Note: When using AUDIO IN(PC/MIC)
terminal as MIC input, these terminals can
be used for PC audio input.