Sanyo PLC-XK3010 - Manual (Page 20)

0
TO MAINTAIN THE LIFE OF THE LAMP,
ONCE YOU TURN THE PROjECTOR ON,
WAIT AT LEAST FIVE MINUTES BEFORE
TURNING IT OFF .
Power off? disappears after 4 seconds.
Turning Off the Projector
Press the ON/STAND-BY button on the top control
or on the remote control, and Power off? appears
on the screen.
Press the ON/STAND-BY button again to turn off the
projector. The POWER indicator starts to blink red,
and the cooling fans keep running. (You can select
the level of fans’ quietness and speed. See “Fan” on
page 55.) At this time, you can unplug the AC power
cord even if the fans are still running.
1
2
3
When the projector has cooled down enough, the
POWER indicator stops blinking and you can turn on
the projector.
 Note:
• When the Direct on function is set to On,
the projector will be turned on automatically
by connecting the AC power cord to an AC
outlet (p.49).
• The running speed of cooling fans is
changed according to the temperature inside
the projector.
• Do not put the projector in a case before the
projector is cooled enough.
• If the WARNING indicator blinks or lights red,
see “WARNING indicator” on page 58.
• While the POWER indicator is blinking, the
lamp is being cooled down and the projector
cannot be turned on. Wait until the POWER
indicator stops blinking to turn on the
projector again.
• The fan rotation will terminate directly if the
AC power cord is unplugged immediately
after the projector is turned off.
• The projector can be turned on after the
POWER indicator turns red. The waiting
time to restart will be shortened when the
normal power-off processing for fan cooling
is completed, compared with the time the AC
power cord is immediately unplugged after
the power-off.
Basic Operation
DO NOT OPERATE THE PROjECTOR
CONTINUOUSLY WITHOUT REST.
CONTINUOUS USE MAY RESULT IN
SHORTENING THE LAMP LIFE. TURN OFF
THE PROjECTOR AND LET STAND FOR
ABOUT AN HOUR IN EVERY 24 HOURS.
 Note:
• When using the Direct OFF function, you can
not restart the projector immediately after
the power is disconnected. If the external
power supply is suddenly cut off, the fans
stop immediately. The lamp remains high
temperature and needs to be cooled.
You can disconnect the power cord from the wall outlet
or turn off the breaker even during projection without
pressing the ON/STAND-BY button.
Direct OFF Function