beautypg.com

Replacing the filter, Resetting the filter counter, Maintenance and cleaning – Sanyo PLC-XK3010 User Manual

Page 59: 12 resetting the filter counter, 3replacing the filter

background image

59

Maintenance and Cleaning

Filter prevents dust from accumulating on the optical elements inside the projector. Should the Filter become

clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup

and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, replace the Filter

immediately. Replace the filter by following the steps below.

CAUTION

- Do not operate the projector with the filters

removed. Dust may accumulate on the optical

elements degrading picture quality.

- Do not put anything into the air vents. Doing so

may result in malfunction of the projector.

- Do not wash the filter with water or any other

liquid Matter. Otherwise the filter may be

damaged.

RECOMMENDATION

We recommend avoiding dusty/smoky

environments when you operate the

projector. Usage in these environments

may cause poor image quality.

When using the projector under dusty or smoky

conditions, dust may accumulate on a lens,

LCD panels, or optical elements inside the

projector degrading the quality of a projected

image. When the symptoms above are

noticed, contact your authorized dealer or

service center for proper cleaning.

Be sure to reset the Filter counter after cleaning or

replacing the filters.

Press the MENU button to display the On-

Screen Menu. Use the Point ▲▼ buttons to

select Setting and then press the Point ► or the

SELECT button.

Use the Point ▲▼ buttons to select

Filter

counter and then press the Point ► or the

SELECT button. Use the Point ▲▼buttons to

select

Filter counter reset and then press the

SELECT button.

Filter counter Reset? appears.

Select

Yes to continue.

1

2

Resetting the Filter Counter

Filter counter reset

Filter counter

Reset? appears.

Select

Yes, then

another confirmation

box appears.

Select

Yes again

to reset the Filter

counter.

Another confirmation dialog box appears, select

Yes to reset the Filter counter.

3

Replacing the Filter

Turn off the projector, and unplug the AC power

cord from the AC outlet.
Put you finger on the latch’s  mark, pull it the

unlock position and remove.

1

2

Put the new one back into the position.

Put you finger on the latch’s  mark, pull it the

lock position to lock.

3

4

Filter

Latch

Connect the AC power cord to the projector and

turn on the projector.

5

Reset the filter counter.

Unlock

Lock

Note:

• When replacing the filter,

it is required a certain

space to pull out the filter

completely.

• When installing the

projector, install the

projector with keeping a

certain space for replacing

the filter.