beautypg.com

Setting – Sanyo PLC-XK3010 User Manual

Page 47

background image

47

Setting

Capture

Capture

This function enables you to capture an image being

projected to use it for a starting-up display or interval of

presentations.

Select

Capture and press the SELECT button.

A confirmation box appears and select

Yes to capture

the projected image.

After capturing the projected image, go to the Logo

select function and set it to

User. Then the captured

image will be displayed the next time you turn on the

projector or when you press the NO SHOW button. (see

page 6)

To cancel the capture function, select

Yes in the "Quit?"

confirmation box.

Note:

• Before capturing an image, select

Standard in the Image select Menu to

capture a proper image (pp. 3, 39).

• A signal from a computer can be captured

up to XGA (104 x 768). A signal from video

equipment can be captured except for

720p, 1035i, and 1080i.

• When capturing the image that has been

adjusted by the Keystone function, the

adjusted data is automatically reset and

the projector captures an image without

keystone correction.

• When Logo PIN code lock function is set to

On, Logo select and Capture can not be

selected.

• When starting to capture a new image, the

previously stored image is cleared even if

you cancel the capturing.

• When there is no captured image or it is

interrupted while capturing an image,

User

can not be selected, you can only switch

between

Default and Off.

Logo PIN code lock

This function prevents an unauthorized person from

changing the screen logo.

Off ........... The screen logo can be changed freely

from the Logo Menu (p. 46).

On............ The screen logo cannot be changed

without a Logo PIN code.

If you want to change the

Logo PIN code lock

setting, press the SELECT button and the Logo PIN

code dialog box appears. Enter a Logo PIN code by

following the steps below. The initial

Logo PIN code is

set to “431” at the factory.

Logo PIN code lock

Quit?

Quit?

Setting