beautypg.com

Appendix – Sanyo PLC-XK3010 User Manual

Page 64

background image

64

Appendix

No image

– Check the connection between your computer or video

equipment and the projector. See pages 14-16.

– See if the input signal is correctly output from your computer.

Some laptop computers may need to change the setting for

monitor output when connecting to a projector. See your

computer’s instruction manual for the setting.

– It takes about 30 seconds to display an image after turning on

the projector. See page 18.

– Check the Input signal, color system, video system or computer

system mode.

– Make sure the temperature is not out of the specified Operating

Temperature (41˚F–95˚F [5˚C–35˚C]).

– When

No Show is operating, the image cannot be displayed.

Press the NO SHOW button or any other button on the

remote control.
No sound

– Check the audio cable connection from audio input source.

– Adjust the audio source.

– Press the Volume + button. See page 4.

– Press the Mute button. See page 4.

– When the AUDIO OUT is plugged-in, the projector's built-in

speaker is not available.

– Is the image projected? You will hear the Computer and Video

sound only when the image is projected.

The color is strange.

– Check the Input signal, color system,video system or computer

system mode.

– Make sure the

Blackboard is not selected on Image select

menu. See pages 3, 39.

Some displays are not seen

– Check the Display function. See page 46.

during the operation.

Auto PC adjustment function – Check the Input signal. Auto PC adjustment function can not

does not work . work when 480p, 575p, 720p, 480i, 575i, 1035i or 1080i is

selected. See page 9.

The setting does not remain

– Make sure you selected

Store after adjusting setting. Some

after turning off power.

settings can not be stored if not registered with

Store. See

pages 33, 41.

Power management does not – Power management function can not work while Freeze or No

work .

Show function is running. See page 49.

Capture function does – Check the connection and the input signal to see if there is

not work .

signal.

Auto setup does not

– Make sure

Off is not selected at any function of Auto setup.

work properly.

See page 45.

– Make sure

On is not selected at the Ceiling function.

See pages 35, 43.

Auto keystone function does not – Make sure the Auto keystone function is not set to Manual.

work even when the projector is Press the AUTO SETUP button on the top control. See

tipped . pages 3, 45.