beautypg.com

Setting – Sanyo PLC-XK3010 User Manual

Page 52

background image

5

Remote control

This projector provides two different remote control

codes: the factory-set initial code (

Code 1) and the

secondary code (

Code 2). This switching function

prevents remote control interference when operating

several projectors or video equipment at the same time.

When operating the projector in

Code 2, both the

projector and the remote control must be switched to

Code 2.

To change the code for the projector:

Select either

Code 1 or Code 2 in this Setting Menu.

To change the code for the remote control:

Press and hold both the MENU and IMAGE buttons

together for 5 seconds or more. After changing the code,

make sure the remote control operates properly.

Note:

• When different codes are set on the projector

and on the remote control, any operation

cannot be made. In that case, switch the

code on the remote control to fit the code on

the projector.

• If the batteries are removed from the remote

control for a long period of time, the remote

control code will be reset.

Remote control

Setting

This function allows you to change brightness of the

screen.

Lamp control

Note:

• Lamp mode can not be changed for a while

after turning on the projector. Lamp needs

some time to stabilize after the power is

turned on. Stored lamp mode will be active

after the lamp is stabilized.

High ........... Brighter than the Normal mode.

Normal ....... Normal brightness

Eco ............ Lower brightness reduces the lamp

power consumption and extends the

lamp life.