Appendix – Sanyo PLC-XK3010 User Manual
Page 65

65
The image is distorted or runs off. – Check PC adjust menu or Screen menu and adjust them.
See pages 30-31, 34-35.
PIN code dialog box appears
– PIN code lock is being set. Enter a PIN code (the “134” or numbers
at start-up .
you have set). See pages 19, 53-54.
The Remote Control does
– Check the batteries.
not work .
– Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 5.
– Unlock the Key lock function for the remote control function.
See page 53.
Indicator blinks or lights.
– Check the status of the projector with referring to "Indicators and
projector Condition". See page 69.
The exclamation mark appears
– Your operation is invalid. Operate correctly.
on the screen.
Top control does not work. – The top control is not available if the top control is locked at Key lock
under
Security of SETTING section. See page 53.
Unable to unlock the Logo PIN
– Contact the dealer where you purchased the projector or the service
code lock, Security key lock
center.
or Security PIN code lock.
– The projector detects an abnormal condition. Unplug the AC power cord
and contact the dealer where you purchased the projector or the service
center.
appears on the screen
Appendix