Computer input – Sanyo PLC-XK3010 User Manual
Page 27

7
Choose either
Computer 1(RGB) or Computer 2(RGB) by pressing the COMPUTER 1 or COMPUTER button on
the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described below.
1
Input Menu
2
3
Note:
When the Input Search function is set to
On 1 or On 2 in the Auto setup function, the
input signal will be searched automatically
(p.45).
Computer
1
Remote Control
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select
Input
and then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select
Computer 1.
When
Computer 1 is selected, press the Point
► button to access the submenu items. Use the
Point ▲▼ buttons to select the RGB input source
and then press the SELECT button.
COMPUTER 1 button
Computer 1(RGB)
Computer 1(Scart)
Input Source Selection (RGB: Computer 1/Computer 2)
Computer 2 (RGB)
COMPUTER 2 button
Direct Operation
Menu Operation
Computer Input
OR
Use the Point ▲▼ buttons to select
Computer 2
and then press the SELECT button.