beautypg.com

Setting – Sanyo PLC-XK3010 User Manual

Page 49

background image

49

Terminal

The COMPUTER IN /MONITOR OUT terminal on the

back of the projector is switchable for computer input

or monitor output. (See page 9) Select

Computer 2 or

Monitor Out with the Point ▲▼ buttons.

Computer 2 . . computer input

Monitor Out . . monitor out

Terminal function is not available when selecting

Computer 2 to the input source. Change the input

source to the others (

Computer 1, and so on) so that

the Terminal function will be available. (pp.5, 36, 37)

Setting

Time left before Lamp is off.

Power management

For reducing power consumption as well as maintaining

the lamp life, the Power management function turns off

the projection lamp when the projector is not operated

for a certain period.

Select one of the following options:

Ready ............... When the lamp has been fully

cooled down, the POWER

indicator changes to green

blinking. In this condition, the

projection lamp will be turned on

if the input signal is reconnected

or any button on the top control or

remote control is pressed.

Shut down ....... When the lamp has been fully

cooled down, the power will be

turned off.

Off .................... Power management function is

off.

Timer ................ If the input signal is interrupted

and no button is pressed for more

than 30 seconds, the timer display

with

No signal appears. It starts

the countdown until the lamp is

turned off. Use the Point ▲▼

buttons to set the Timer (1~30

min).

Note:

Factory default is

Ready: 5 min.

Power management

When this function is set to

On, the projector will be

automatically turned on just by connecting the AC

power cord to a wall outlet.

Note:

• Be sure to turn off the projector properly

(see “Turning Off the Projector” on page

0). If the projector is turned off in the

incorrect sequence, the Direct on function

will not work properly.

Direct on