beautypg.com

Remote control battery installation, Remote control operating range, Remote control code – Sanyo PLC-XK3010 User Manual

Page 12: Part names and functions

background image

1

Part Names and Functions

To ensure safe operation, please observe the following precautions :

● Use two (2) AAA or LR03 type alkaline batteries.

● Always replace batteries in sets.

● Do not use a new battery with a used battery.

● Avoid contact with water or liquid.

● Do not expose the remote control to moisture or heat.

● Do not drop the remote control.

● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

● Risk of an explosion if battery is replaced by an incorrect type.

● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Open the battery

compartment lid.

Install new batteries

into the compartment.

Replace the

compartment lid.

Two AAA size batteries

For correct polarity (+

and –), be sure battery

terminals are in contact

with pins in compartment.

1

2

3

Point the remote control toward the projector (Infrared

Remote Receiver) when pressing the buttons. Maximum

operating range for the remote control is about 16.4'(5

m) and 60 degrees in front of the projector.

Remote Control Operating Range

Remote Control Battery Installation

16.4'

(5 m)

30° Remote control

30°

The different remote control codes (Code 1–Code

) are assigned to this projector. Switching the remote

control codes prevents interference from other remote

controls when several projectors or video equipment next

to each other are operated at the same time. Change the

remote control code for the projector first before changing

that for the remote control. See "Remote control" in the

Setting Menu on page 5.

Press and hold the MENU and IMAGE buttons for more

than five seconds to switch between the

Code 1 and

Code 2. The initial code is set to Code 1.

Remote Control Code

MENU button

IMAGE button