SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 469)

P
RIORITY
C
OMMANDS
4-221
queue mode
This command sets the queue mode to strict priority or Weighted
Round-Robin (WRR) for the class of service (CoS) priority queues. Use the
no form to restore the default value.
Syntax
queue mode {strict | wrr}
no queue mode
• strict - Services the egress queues in sequential order, transmitting
all traffic in the higher priority queues before servicing lower
priority queues.
• wrr - Weighted Round-Robin shares bandwidth at the egress ports
by using scheduling weights 1, 2, 4, 6 for queues 0 - 3 respectively.
Default Setting
Weighted Round Robin
Command Mode
Global Configuration
queue bandwidth Assigns round-robin weights to the priority
queues
GC 4-223
queue cos map Assigns class-of-service values to the
priority queues IC 4-224
show queue mode Shows the current queue mode PE 4-225
show queue
bandwidth Shows round-robin weights assigned to the
priority queues PE 4-226
show queue
cos-map Shows the class-of-service map PE 4-226
show interfaces
switchport Displays the administrative and operational
status of an interface PE 4-154
Table 4-58 Priority Commands (Layer 2) (Continued)
Command Function Mode Page