SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 108)

C
ONFIGURING THE
S
WITCH
3-54
CLI – Specify all the required parameters to enable logon authentication.
Configuring HTTPS
You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch’s web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on
the switch. However, you cannot configure both services to use the
same UDP port.
• If you enable HTTPS, you must indicate this in the URL that you
specify in your browser: https://device[:port_number]
Console(config)#authentication login radius 4-94
Console(config)#radius-server port 181 4-98
Console(config)#radius-server key green 4-98
Console(config)#radius-server retransmit 5 4-99
Console(config)#radius-server timeout 10 4-99
Console(config)#radius-server 1 host 192.168.1.25 4-97
Console(config)#end
Console#show radius-server
4-100
Remote RADIUS server configuration:
Global settings:
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Server 1:
Server IP address: 192.168.1.25
Communication key with RADIUS server: *****
Server port number: 1812
Retransmit times: 2
Request timeout: 5
Console#configure
Console(config)#authentication login tacacs
4-94
Console(config)#tacacs-server host 10.20.30.40 4-101
Console(config)#tacacs-server port 200 4-102
Console(config)#tacacs-server key green 4-102
Console#show tacacs-server 4-103
Server IP address: 10.20.30.40
Communication key with tacacs server: *****
Server port number: 200
Console#