SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 405)

M
IRROR
P
ORT
C
OMMANDS
4-157
• The destination port is set by specifying an Ethernet interface.
• The mirror port and monitor port speeds should match, otherwise
traffic may be dropped from the monitor port.
• You can only create a single mirror session.
Example
The following example configures the switch to mirror received packets
from port 6 to 11:
show port monitor
This command displays mirror information.
Syntax
show port monitor [interface]
• interface - ethernet unit/port (source port)
- unit - Stack unit.
(Range – SMC6224M: 1-8, SMC6248M: 1-4, mixed stack: 1-4)
- port - Port number. (Range: 1-26/50)
Default Setting
Shows all sessions.
Command Mode
Privileged Exec
Command Usage
This command displays the currently configured source port,
destination port, and mirror mode (i.e., RX, TX).
Console(config)#interface ethernet 1/11
Console(config-if)#port monitor ethernet 1/6 rx
Console(config-if)#