SMC Networks SMC TigerStack IV SMC6224M - Manual (Page 409)

L
INK
A
GGREGATION
C
OMMANDS
4-161
show rate-limit
Use this command to display the rate limit granularity.
Default Setting
Fast Ethernet interface – 3.3 Mbps
Gigabit Ethernet interface – 33.3 Mbps
Command Mode
Privileged Exec
Command Usage
• For Fast Ethernet interfaces, the rate limit granularity is 8 Kbps,
64 Kbps, 512 Kbps, 1 Mbps, 2 Mbps, or 3.3 Mbps.
• For Gigabit Ethernet interfaces, the rate limit granularity is 32 Kbps,
64 Kbps, 512 Kbps, 1 Mbps, 2 Mbps, 3.3 Mbps, 10 Mbps, or
33.3 Mbps.
Example
Link Aggregation Commands
Ports can be statically grouped into an aggregate link (i.e., trunk) to
increase the bandwidth of a network connection or to ensure fault
recovery. Or you can use the Link Aggregation Control Protocol (LACP)
to automatically negotiate a trunk link between this switch and another
network device. For static trunks, the switches have to comply with the
Cisco EtherChannel standard. For dynamic trunks, the switches have to
comply with LACP. This switch supports up to four trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate
bandwidth of 4 Gbps when operating at full duplex.
Console#show rate-limit
Fast ethernet granularity: 1000
Gigabit ethernet granularity: 33300
Console#